Descrizione

The SCA-35 Stereo Control Amplifier is a complete stereo preamplifier and stereo power amplifier, combined on a single chassis with a single power supply. It uses premium grade components conservatively operated. The preamplifier printed circuit module amplifies the selected low level signal for each stereo channel through two stages (the two halves of a 12AX7 tube). Dual tone controls consist of passive networks, each encapsulated in a PEC. Each power amplifier, on a separate printed circuit module, uses a 7199 tube and two 6BQ5 output tubes, along with an optimized (Dynaco Z-565) transformer. A single cathode resistor is used for all four output tubes, which necessitates matching of the tubes.

The power supply uses a transformer and silicon diode full wave rectification, and provides individual hum adjustments for each channel on the back panel, along with two ac convenience outlets. The front panel is champagne gold, anodized aluminum, with die cast knobs, and includes switches for mono-stereo, loudness compensation, filter, and power.

Specifications:

Inputs: Low and high level magnetic phono, ceramic phono, NAB 7-1/2" tape head, radio, tape, spare

Outputs: Tape, 8 and 16 ohm speakers, center channel loudspeaker, headphone provision.

Controls: Selector, Volume, Balance, Blend, Individual Treble and Bass for each channel, Tape Monitor, Loudness, Scratch Filter, Power.

35 watts continuous;

Frequency Response: ±.5 dB 10 cps to 40 kc. Response not affected by position of volume control.

Power Response: 20 cps to 20 kc without exceeding 1 percent distortion within 1 dB of 17.5 watts, each channel)

Tone Control Range:

±12 dB at 15 kc; ±12 dB at 50 cps.

Sensitivity for rated output:

2.5 mV at tape head; 4 mV at low level magnetic phono; 1 volt at high level.

IM Distortion:less than 1 percent at 17.5 watts (each channel), less than 0.2 percent at average levels.

Hum and Noise:

70 dB below 10 millivolt input for rated output on low level inputs; 80 dB on high level.

Power consumption: 110 watts, 120 volts, 60 cycle AC (120/240 volt, 50/60 cycle operation available with optional PB-028 transformer).

Tube complement: 12AX7/ECC83 (2), 7199 (2), 6BQ5/EL-84/7189 (4)

Silicon diodes: 500 mA, 1000 PIV (2)

Di cosa si tratta: Ampli Integrato

Produttore: Dynaco

Caratteristiche: 35 watt

Costo: -

Specifiche

Tipologia amplificazione	valvolare
Valvole utilizzate	12AX7/ECC83 (2), 7199 (2), 6BQ5/EL-84/7189 (4)
Potenza RMS per canale	35 W
Carico di riferimento	8 ohm
Stadio phono	MM
Ingressi analogici	Low level magnetic phono, high level magnetic phono, ceramic phono, NAB 7-1/2" tape head, radio, tape, spare
Risposta in frequenza	10 Hz - 40 kHz
Distorsione armonica (THD)	1 %
Consumo elettrico	110 W
Alimentazione	120 volts, 60 cycle AC
Anno produzione	1964
Paese di origine	USA
Finitura	champagne gold anodized aluminum